Revolusi Keamanan Berkendara : Sistem Keselamatan Berbasis Mikrokontroller

Authors

  • Hadian Mandala Putra Universitas Hamzanwadi https://orcid.org/0000-0002-9807-9989
  • Taufik Akbar
  • Ahmad Hafifan Triadi Putra Universitas Hamzanwadi
  • Ida Wahidah Universitas Hamzanwadi
  • Suhartini Universitas Hamzanwadi

DOI:

https://doi.org/10.29408/jit.v7i2.26119

Keywords:

Arduino Uno, touch sensor, rfid card, sistem keamanan dan keselamatan, RFID, Touch Sensor, Security and Safety System

Abstract

The increasing need for transportation, especially motorcycles, has led to many illegal methods and criminal actions by individuals committing motorcycle theft. Fundamentally, security and safety are the primary concerns motorcycle users must pay attention to on the road. Many vehicle users neglect safety while riding, such as inappropriate driving. Some actions endanger themselves and other drivers, like using a cell phone while riding, causing the rider to lose focus. Therefore, this research offers a solution as a microcontroller-based security and safety system aimed at minimizing motorcycle theft and improving riding safety. The solution from this research is to produce a microcontroller-based technology utilizing RFID for security, touch sensors, and push buttons for safety when the rider does not follow proper riding procedures. The Research & Development method is used in this research, with five stages: analysis, design, development, implementation, and evaluation. The results of this study are a prototype of a security and safety system based on an Arduino Uno microcontroller as the control center. Regarding security, the vehicle starts only with registered access in the control center, which is then placed on the RF reader installed on the car. From the test results, using an e-KTP as the vehicle access medium successfully started the motorcycle with a 0% error rate from 10 trials. Regarding rider safety, using a touch sensor to test the number of passengers was successful, with an 80% success rate from 10 trials. The push button succeeded with a 100% success rate from 10 trials when users did not position their hands on both motorcycle handles (bars) and successfully triggered the alarm when the rider was not riding correctly.

References

B. P. N. T. Barat, PROVINSI NUSA TENGGARA BARAT DALAM ANGKA. Nusa Tenggara Barat: BPS Provinsi Nusa Tenggara Barat, 2023.

B. P. S. P. N. T. Barat, Statistik Kriminalitas 2021. Mataram: Badan Pusat Statistik Provinsi Nusa Tenggara Barat, 2021.

B. B. Aji and M. K. Kelviandy, “Pemanfaatan RFID dalam Sistem Keamanan Motor Berbasis Arduino ( Radio Frequency Identification ),” J. Pendidik. Tambusai, vol. 7, pp. 3758–3768, 2023.

M. Ridha Fauzi, “Rancang Bangun Pengaman Sepeda Motor Menggunakan RFID Berbasis Arduino,” J. Surya Tek., vol. 7, no. 2, pp. 164–171, 2020, doi: 10.37859/jst.v7i2.2384.

F. Harahab, Y. Trimarsiah, and D. S. Agustina, “Sistem Pengaman Kunci Sepeda Motor Mengunakan RFID ( Radio Frequancy Indentification ) Berbasis Mikrocontoller Atmega 328,” J. Intech, vol. 1, no. 2, pp. 1–5, 2020.

Z. Oby, Jagoan Arduino. Yogyakarta: Indobot Robotic Center, 2018.

D. Sasmoko, Arduino dan Sensor, vol. 1. Semarang: Yayasan Prima AgusTeknik, 2021.

Destiarini and P. W. Kumara, “Robot Line Follower Berbasis Mikrokontroller Arduino Uno ATmega328,” J. Informanika, vol. 5, no. 1, pp. 18–25, 2019.

A. Leo and A. Azis, “Kunci Pintu Otomatis Mengunakan Rfid,” J. Ampere, vol. 6, no. 1, pp. 43–48, 2021.

M. Dr. Ir. Agus Wibowo, M.Kom., M.Si., Aplikasi Teknologi RFID pada IoT. Semarang: Yayasan Prima Agus Teknik, 2021.

D. M. Bagus Setiaji, “Sistem Peringatan Menggunakan Sensor Sentuh Pada Bracket Lcd Proyektor Otomatis Berbasis Mikrokontroler At 89S51,” J. Chem. Inf. Model., vol. 53, no. 9, pp. 1689–1699, 2019.

I. Y. Basri and D. Irfan, Komponen Elektronika, vol. 53, no. 9. Padang: SUKABINA Press, 2018.

M. Khalil, dwi K. Artika, and Adhhani, “Penambahan Fitur Saklar On Off Standar Samping pada Honda Supra x 125 R,” J. Tek. Mesin, vol. 7, no. 2, pp. 99–107, 2020.

A. Risal, Mikrokontroler dan Interface. Makassar: Universitas Negeri Makassar, 2017.

A. Siswanto, R. Sitepu, D. Lestariningsih, L. Agustine, A. Gunadhi, and W. Andyardja, “Meja Tulis Adjustable dengan Konsep Smart Furniture,” Sci. J. Widya Tek., vol. 19, no. 2, pp. 2621–3362, 2020.

I. Rofii and D. U. Azmi, “Karakteristik Listrik dan Optik pada LED dan Laser ( Electrical and Optical Characteristics of LED and Laser ),” J. Teor. dan Apl. Fis., vol. 08, no. 02, pp. 203–208, 2020.

P. D. Sugiyono, METODE PENELITIAN KUANTITATIF, KUALITATIF, DAN R&D. Bandung: ALFABETA, 2017.

Downloads

Published

23-07-2024

How to Cite

Hadian Mandala Putra, Akbar, T., Hafifan Triadi Putra, A., Ida Wahidah, & Suhartini. (2024). Revolusi Keamanan Berkendara : Sistem Keselamatan Berbasis Mikrokontroller. Infotek: Jurnal Informatika Dan Teknologi, 7(2), 608–617. https://doi.org/10.29408/jit.v7i2.26119

Similar Articles

<< < 9 10 11 12 13 14 15 16 17 18 > >> 

You may also start an advanced similarity search for this article.