Pengaruh Slice Thickness terhadap Signal to Noise Ratio (SNR) dari Hasil Penyinaran CT Scan di RSUP Prof. Dr. I.G.N.G Ngoerah

Authors

  • Lusi Putu Russita Kusumaningsih Program Studi Fisika, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Udayana
  • I Bagus Made Suryatika Program Studi Fisika, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Udayana
  • Ni Luh Putu Trisnawati Program Studi Fisika, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Udayana
  • Rozi Irhas Program Studi Fisika, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Udayana

DOI:

https://doi.org/10.29408/kpj.v7i2.7675

Keywords:

CT Scan, slice thickness, SNR value, image quality

Abstract

A research has been carried out on the effect of slice thickness on SNR values from the results of CT Scan irradiation at Prof. Dr. I.G.N.G Ngoerah Hospital.  Variations in the thickness of the slices used are 1 mm, 3 mm, 5 mm, and 7 mm.  The tube voltage, tube current, and FOV used are constant, namely 120 kV, 200 mA, and 380 mm.  SNR value analysis was calculated using the average object value and SD background for each material.  Based on the results of a simple linear regression test, the thickness of the slices obtained has an effect of 99.9% on the SNR value.  These results indicate that the greater the thickness of the slice used, so the SNR value will increasesas the SNR value increases, it will improve image quality.

References

Dewi, P. S., Ratini, N. N., & Trisnawati, N. L. P. (2022). Effect of x-ray tube voltage variation to value of contrast to noise ratio (CNR) on computed tomography (CT) Scan at RSUD Bali Mandara. International Journal of Physical Sciences and Engineering, 6(2), 82-90.

Hutami, I. A. P. A., Sutapa, G. N., & Paramarta, I. B. A. (2021). Analisis Analisis Pengaruh Slice Thickness Terhadap Kualitas Citra Pesawat CT Scan Di RSUD Bali Mandara. BULETIN FISIKA, 22(2), 77-83.

Lestari, A. A., Sutanto, H., & Arifin, Z. (2014). Analisis Noise Level Hasil Citra CT Scan Pada Tegangan Tabung 120 kV dan 135 kV Dengan Variasi Ketebalan Irisan (Slice Thickness). Youngster Physics Journal, 3(3), 189-196.

Louk, A. C., & Suparta, G. B. (2014). Pengukuran Kualitas Sistem Pencitraan Radiografi Digital Sinar-X. Bimipa, 24(2), 149-166.

Nurhayati, A. Y., Nariswari, N. N., Rahayuningsih, B., & Hariadi, Y. C. (2019). Analisis Variasi Faktor Eksposi dan Ketebalan Irisan Terhadap CTDI dan Kualitas Citra Pada Computed Tomography Scan. BERKALA SAINSTEK, 7(1), 7-12.

Satwika, L. G. P., Ratini, N. N., & Iffah, M. (2021). Pengaruh Variasi Tegangan Tabung Sinar-X terhadap Signal to Noise Ratio (SNR) dengan Penerapan Anode Heel Effect menggunakan Stepwedge. Buletin Fisika, 22(1), 20-28.

Siregar, E. S., Sutapa, G. N., & Sudarsana, I. W. B. (2020). Analisis Dosis Radiasi Pasien Pada Pemeriksaan CT Scan Menggunakan Aplikasi Si-INTAN. Buletin Fisika, 21(2), 53-59.

Sookpeng, S., Martin, C. J., & Butdee, C. (2019). The investigation of dose and image quality of chest computed tomography using different combinations of noise index and adaptive statistic iterative reconstruction level. Indian Journal of Radiology and Imaging, 29(01), 53-60.

Wijaya, I. K. S. N., Astina, K. Y., Wulandari, P. I., & Jeniyanthi, N. P. R. (2019). ANALISA JEDA WAKTU PEMBACAAN IMAGING PLATE TERHADAP SIGNAL TO NOISE RATIO (SNR) PADA PEMERIKSAAN MAMMOGRAFI. IMEJING: Jurnal Radiografi Indonesia, 3(1).

Yusnida, A. M., & Suryono, S. (2014). Uji Image Uniformity Perangkat Computed Radiography Dengan Metode Pengolahan Citra Digital. Youngster Physics Journal, 3(4), 251-256.

Downloads

Published

2023-08-31

Issue

Section

Articles